Red4
The Red4 is a moving iron phono cartridge from Grado's Prestige Series, offered in standard half-inch mount and P-mount versions. It has an elliptical diamond stylus and a high 4 mV output, so it suits a wide range of turntables and phono stages.
- Moving iron cartridge from the Grado Prestige Series
- Bonded elliptical diamond on an aluminum cantilever
- 4 mV output; 10k–47k ohm input load
- Standard 1/2" mount or P-mount versions
- User-replaceable stylus, interchangeable across Prestige Series
- 5N OCC copper signal path, cryogenically treated
Φωτογραφίες
8Αγγελίες
Δεν υπάρχουν ακόμα αγγελίες για αυτό το μοντέλο
Όταν κάποιος πουλήσει ένα Red4, οι αγγελίες και το ιστορικό πωλήσεων θα εμφανίζονται εδώ.
Πούλησε ένα τέτοιοΠεριγραφή
Red4 is an entry-level model in the Prestige Series that uses Grado's moving iron design, based on the flux-bridger principle. The coils stay fixed while the moving mass is kept very low. The body is die-injection molded, and the internal signal path uses 5N OCC copper. Each cartridge is cryogenically treated and internally damped to reduce resonance.
The stylus is a bonded elliptical diamond on an aluminum cantilever. The stylus assembly can be replaced by the user, and all Prestige Series styli are interchangeable between models. Output is 4 mV, so the cartridge is intended to work with a broad range of phono stages. It is described as balanced and controlled, with a smooth top end, a present midrange and defined low frequencies.
It is available in two mounting versions: a standard 1/2-inch screw mount and a P-mount that plugs straight into compatible tonearms. Recommended tracking force is 1.6 to 1.9 grams, and the cartridge weighs 6 grams. Input load is 10k to 47k ohms.
Προδιαγραφές
- Μάρκα
- Grado
- Μοντέλο
- Red4
- Κατηγορία
- Εξοπλισμός DJ › Κεφαλές και βελόνες
Audio
- Output
- 4 mV @ 5 CMV (45 degrees)
- Frequency response
- 10-55,000 Hz
- Channel separation
- Average 25 dB, 10-30,000 Hz
- Compliance
- 20 µm/mN
Electrical
- Input load
- 10k - 47k ohms
- Inductance
- 50 mH
- DC resistance
- 660 ohms
Stylus
- Stylus
- Diamond, elliptical
- Cantilever
- Aluminum
- Generator type
- Moving iron
- Stylus replacement
- User-replaceable
Setup
- Tracking force
- 1.6 - 1.9 grams
- Mounting
- P-mount or 1/2" screw mount
- Mount options
- Standard Mount, P-Mount
Physical
- Cartridge weight
- 6 grams
- Housing
- Die-injection molded
- Internal wiring
- 5N OCC copper
- Series
- Prestige Series