Pick it MC1
Entry-level moving-coil phono cartridge with a spherical stylus on an aluminium cantilever and a resonance-optimised ABS body. Aimed at listeners moving up from MM cartridges who use entry to mid-level turntables with a suitable phono stage.
- Moving-coil cartridge with neodymium N40H magnet
- 6N OFC pure copper windings, square generator coil
- Spherical diamond stylus on aluminium cantilever
- Output 0.4 mV at 1 kHz
- Recommended tracking force 1.9 g
- Threaded holes for nut-free 1/2 inch mounting
Φωτογραφίες
6Αγγελίες
Δεν υπάρχουν ακόμα αγγελίες για αυτό το μοντέλο
Όταν κάποιος πουλήσει ένα Pick it MC1, οι αγγελίες και το ιστορικό πωλήσεων θα εμφανίζονται εδώ.
Πούλησε ένα τέτοιοΠεριγραφή
The Pick it MC1 is a moving-coil cartridge built around a neodymium N40H magnet, a square generator coil and 6N OFC pure copper windings. A spherical diamond sits on an aluminium cantilever, and the body is made from resonance-optimised ABS, giving a total weight of about 5 grams.
Because the stylus and coil assembly is light, an MC design offers wider frequency range and faster transient response than a typical MM cartridge, and its low source impedance reduces sensitivity to hum. Output is about 20 dB lower than an MM type, so a high-quality phono stage is recommended. Medium compliance suits most entry to mid-level turntables.
It mounts to the standard 1/2 inch headshell spacing and has threaded holes, so it can be fitted without nuts. Tracking force is 1.7–2.1 g with 1.9 g recommended, and the recommended load resistance is 100–470 Ω.
Προδιαγραφές
- Μάρκα
- Pro-Ject
- Μοντέλο
- Pick it MC1
- Κατηγορία
- Εξοπλισμός DJ › Κεφαλές και βελόνες
Cartridge
- Cartridge principle
- MC (Moving-Coil)
- Magnet
- Neodymium N40H
- Generator coil
- Square
- Windings
- 6N OFC pure copper
- Stylus type
- Spherical on alu cantilever
- Enclosure
- Resonance optimized ABS
Audio
- Output voltage at 1 kHz
- 0,4 mV (3,54 cm/sec)
- Channel separation at 1 kHz
- >27 dB
- Tracking ability at 315Hz
- 70 μm
- Dynamic compliance
- 18 μm/mN
- Frequency response
- 20 - 20 000 Hz +/- 1dB
- Recommended load resistance
- 100-470 Ω
Setup
- Tracking force, range
- 1,7 - 2,1 g (mN)
- Tracking force, recommended
- 1,9 g (mN)
- Height stylus tip to top mounting surface
- 17 mm
- Tracking angle
- 22°
- Mounting
- 1/2 inch standard, threaded holes
Physical
- Cartridge weight
- 5 g