Pick it MM EVO
Moving-magnet phono cartridge made by Ortofon and voiced by Pro-Ject, with an elliptical stylus and 7 mV output. It suits turntables with low to medium mass tonearms and uses the standard half-inch mounting.
- Moving-magnet cartridge made by Ortofon, voiced by Pro-Ject
- Elliptical stylus, r/R 8/18 µm
- 7 mV output voltage
- Recommended tracking force 1.8 g (range 1.6–2 g)
- Suits low to medium mass tonearms
- Half-inch mounting with threaded holes; stylus sold separately
Φωτογραφίες
8Αγγελίες
Δεν υπάρχουν ακόμα αγγελίες για αυτό το μοντέλο
Όταν κάποιος πουλήσει ένα Pick it MM EVO, οι αγγελίες και το ιστορικό πωλήσεων θα εμφανίζονται εδώ.
Πούλησε ένα τέτοιοΠεριγραφή
The Pick it MM EVO is a moving-magnet cartridge built by Ortofon and tuned by the Pro-Ject design team. It carries an elliptical stylus on a robust cantilever derived from those used in DJ cartridges, so it is intended to be durable as well as detailed.
Its motor uses Ortofon split pole pins, which give a flat frequency response said to compare well with moving-coil cartridges. Other listed characteristics include low distortion, a wide dynamic range and suitability for low to medium tonearm masses. Output is 7 mV, with a recommended tracking force of 1.8 g.
The body follows the half-inch mounting standard and has threaded holes, so it can be fitted without nuts. The stylus is available separately as a replacement. The cartridge is made in Europe and is loaded with 47 kΩ and 150–300 pF.
Βίντεο
Προδιαγραφές
- Μάρκα
- Pro-Ject
- Μοντέλο
- Pick it MM EVO
- Κατηγορία
- Εξοπλισμός DJ › Κεφαλές και βελόνες
Cartridge
- Cartridge principle
- MM (Moving-Magnet)
- Stylus type
- elliptical
- Stylus tip radius
- r/R 8/18 μm
- Mounting standard
- 1/2 inch
- Origin
- Made in Europe
Audio
- Output voltage
- 7 mV
- Channel separation at 1 kHz
- 22 dB
- Trackability (315 Hz, lateral)
- 70 µm
- Frequency response
- 20 - 20 000 Hz (+3 /-1 dB)
Tracking and loading
- Tracking force, range
- 1,6 - 2 g (mN)
- Recommended tracking force
- 1,8 g (mN)
- Tracking angle
- 20°
- Recommended load resistance
- 47 kΩ
- Recommended load capacitance
- 150 - 300 pF
Physical
- Height stylus tip to top mounting surface
- 18 mm
- Weight
- 7.2 g